Maxon WL7-vers. C, Руководство по установке

Страница: 44 / 61

PATENTS PENDING
44
11921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
PLATFORM TILT ADJUSTMENT (MANDATORY)
1. Make sure power switch
(FIG. 44-1) is turned
on. Lower the platform
and stop approximately 4”
above ground.
NOTE: The platform tilt adjustment is important for operation of the outboard roll-
stop and for keeping platform level when it reaches the ground. Vehicle
fl oor height, Lift and stiffness of the vehicle suspension may change the
angle of platform on the ground.
PLATFORM LOWERED TO GROUND LEVEL
FIG. 44-2
PLATFORM
GROUND
LEVEL
POWER
SWITCH
PLATFORM LOWERED TO GROUND LEVEL
FIG. 44-1
PLATFORM
POWER
SWITCH
GROUND
LEVEL
2. Measure distance from
front of the platform (1) to
the ground (FIG. 44-2) .
Next, measure the distance
from the bottom of the vertical
arm
(2) to the ground
(FIG. 44-2) .
3. The measurement at the vertical
arm (2) must be 1/2” -1” more than
the measurement at the front of
platform
(1) . For example: If you
measure 4” at the front (1) , then you
should measure from 4-1/2” to 5” at
the vertical arm
(2) . If there is not a
1/2” - 1” difference, go to step 4 to
obtain the correct measurement.
(2)
(1)
4”
VERTICAL
ARM