Extended AT Commands Manual
Page 37 of 70
2009-06-25
0
No CBM indications are routed to the TE.
1
If CBM is stored into ME/TA, indication of the memory location is routed to the
TE using unsolicited result code:
+CBMI: <mem>,<index>
2
New CBMs are routed directly to the TE using unsolicited result code:
+CBM: <length><CR><LF><pdu>
(PDU mode enabled); or
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data>
(text mode
enabled)
If ME supports data coding groups which define special routing also for messages other
than class 3 (e.g. (U)SIM specific messages), ME may choose not to route messages of
such data coding schemes into TE (indication of a stored CBM may be given as defined
in
<bm>
=1).
3
Class 3 CBMs are routed directly to TE using unsolicited result
codes defined in
<bm>
=2. If CBM storage is supported, messages of other
classes result in indication as defined in
<bm>
=1
<ds>
0
No SMS-STATUS-REPORTs are routed to the TE.
1
SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
+CDS: <length><CR><LF><pdu>
(PDU mode enabled); or
+CDS: <fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st>
(text mode
enabled)
2
If SMS-STATUS-REPORT is stored into ME/TA, indication of the memory
location is routed to the TE using unsolicited result code:
+CDSI: <mem>,<index>
<bfr>
0
TA buffer of unsolicited result codes defined within this command is flushed to
the TE when
<mode>
1...3 is entered (
OK
response shall be given before flushing the
codes).
1
TA buffer of unsolicited result codes defined within this command is cleared
when
<mode>
1...3 is entered.
8.1.1.11.
List MeCMGL
Execution command returns messages with status value
<stat>
from message storage
<mem1>
to
the TE. About text mode parameters in italics, refer command Show Text Mode Parameters
+CSDH
.
If status of the message is 'received unread', status in the storage changes to 'received read'. If
listing fails, final result code
+CMS ERROR: <err>
is returned. See chapter Message Service
Failure Result Code for
<err>
values.
