Page 10 of 10
M-KIT100/101/102 Assembly Instructions
181-03001
These instructions must be followed exactly. Failure to follow these instructions could damage the product or result in injury to persons using or
assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulting from failure to properly
assemble the product in accordance with these instructions.
Maxon Furniture Inc.
Customer Service: 1-800-876-4274
Unpack the Worksurface UWR2472TM and
1.
hardware kit.
TIP! Be sure to lay the Worksurface on a
soft surface until you are ready to install
it.
Unscrew the Cantilever Brackets from the
2.
Worksurface.
Install two RH Cantilever Brackets in the right
3.
hand slots of Panels A & B at about 28” from
the floor (Figure 14).
With the Cantilever tilted up at about 45°,
4.
slide the top tooth into the panel slot, then
rotate the Cantilever down to engage the
other teeth (Figure 15).
Install the LH Cantilever Bracket in the left
5.
side of panel A as instructed in Steps 3 - 4
(Figure 14).
Attach the Worksurface to the LH and RH
6.
Cantilever Brackets using three #10 x 3/4”
Pan Head Screws in each Cantilever Bracket
(Figure 16).
TIP! A total of nine #10 x 3/4” Pan Head
Screws will be used.
Adding the Worksurface
Figure 16
28"
RH Cantilever
Bracket
LH Cantilever
Bracket
(hidden)
Panel A
Panel B
#10 x 3/4" Pan Head screw
(3 per Bracket, 9 total)
LH Cantilever Bracket
Figure 14
Figure 15
