Maxon DMD-22, Руководство по эксплуатации для пользователя

Страница: 20 / 40

1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
20
TORSION BAR REPLACEMENT & ADJUSTMENT - Continued
3. Unlatch platform (FIG. 20-1) .
Platform should just escape the latch
as shown in
FIG. 20-1, position 1 .
FIG. 20-1
3
2
1
4. Unfold platform until latch pin is 2”-3” from
latch
(FIG. 20-1, position 2) . Release
hold on platform. Observe If platform starts
to fold, stays partially unfolded, or starts
falling open with no restraint. Platform
should unfold slowly when released
(FIG.
20-1, position 3) . To increase the amount
of pull, adjust the torsion bar pin counter-
clockwise until increased tension is applied
to torsion bar
(FIG. 19-1) . Once the platform
is unfolded, it should lay fl at (FIG. 20-1,
position 3). If platform does not lay fl at,
decrease tension by removing cap screw,
lock washer and
fl at washers from LH
torsion bar pin (FIG. 20-2) . Adjust torsion
bar pin clockwise until tension is decreased
(FIG. 20-2A) . Replace cap screw, lock
washer and fl at washers (FIG. 20-2)
and tighten.
5. If additional tension is needed,
stow platform (FIG. 20-3) . Ensure
platform is latched securely. Refer
to
Operation Manual for detailed
operating instructions.
6. Support platform and fl ipover evenly
by placing supports under the RH
and LH runners
(FIG. 20-3) .
PLATFORM
SUPPORT
(2 PLACES)
LH RUNNER
RH RUNNER
FIG. 20-3
DECREASING TENSION
FIG. 20-2
CAP SCREW,
1/2”
LOCK WASHER
FLAT WASHER
(2 PLACES)
TORSION
BAR PIN
FIG. 20-2A
TORSION
BAR PIN