© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 2
REV: 10/14/21
Installation & Operation
Drill fixed holes on the pole for direct bracket
Operating Instructions ARE Series
MaxLite ARE High Efficiency Area Luminaires
®
A: Flexible Arm Mounting:
This fixture can be mounted to a square pole or round pole using the RPA (Round Pole Adapter). The flexible arm can be aimed
0 to 78° both upward and downward in 30° increments (see
FIG. 2
).
1.
If there is no existing hole pattern on the pole, drill holes according to the pattern in
FIG. 3
.
2.
Open the side cover plate on the mounting arm by loosening the 4 M3 screws. (See
FIG. 4
).
3.
Attach the round pole adapter to the mounting bracket if needed. Use the EVA gasket and thread plate if
needed as shown in
FIG. 5
.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Connecting panels to AC source supply: All units must be individually connected to the AC supply.
Black = Line, White = Common, Green = Ground
Fig. 1
