Maxkon WF-40S, Руководство пользователя

Страница: 12 / 15

12
Touch panel/Remote control Operation
BUTTON FUNCTION ACTION&INDICATION
POWER
ON: Enables control panel functions and remote
control.Turn on flame effect.
OFF: Disables control panel functions and remote
control.Turn off flame effect.
1. Press once. Indicator light turns on. Power turns
on. All functions enabled.
2. Press
FLAME
FLAME button: Makes flame effect dimmer and brighter.
NOTE: Flame effect stays on until power button is turned
off. Flame effect must be on for heater to turn on.
1. Press once. Flame brightness effect gets
changing.
2. Press again. Until desired setting is reached.
HEATER
HEATER button:Turn heater on and off.
NOTE: To prevent overheating, the heater fan will blow
out cool air for 30 seconds after the heater turn off.
1. Press once. Indicator lights up. 900W heater
turns on and blows warm air.
2. Press again. Indicator lights up. 1800W heaters
turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 30 seconds to allow
heater to cool down, then turns off.
TEMP.
DOWN
TEMPERATURE button: Control temperature settings to
choose temperature as desired.
Setting range from 16C to 30C
1. Press once. Indicator light turn on. Temperature
is set to 16C
2. Press again, the temperature DOWN until
desired setting is reached. LED display show
setting.
TEMP.
UP
TEMPERATURE button: Control temperature settings to
choose temperature as desired.
Setting range from 16C to 30C
1.Press once. Indicator light turn on. Temperature
is set to 16C
2. Press again, the temperature up until desired
setting is reached. LED display show setting.
TIMER
TIMER button: Control timer settings to turn off fireplace
at selected time.
Settings range from 1 hours to 8 hours.
3. Press once. Indicator light turn on. Temperature
is set1 to 8 hours.
Press again until desired setting is reached. LED
display show setting.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature,
the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
REMOTE CONTROL
NOTICE
When the heater is first turned on, a slight odor may be odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons
too quickly.Give the unit time to respond to each command.