Maximum 054-8286-4, Инструкция по эксплуатации

Страница: 13 / 24

13
GENERAL CUTTING
1. Disconnect the saw from the power supply.
2. Make sure that the workpiece is firmly anchored: clamp the workpiece to keep
it from slipping or moving while cutting.
3. Use the appropriate type and size of blade for the workpiece material and size.
4. Adjust the pivot shoe as necessary to make sure that the blade will extend
beyond the shoe and through the workpiece at all times.
5. Adjust the pivot shoe as necessary to expose unworn blade teeth for longer
blade life.
6. Check for clearance behind the workpiece so that the blade will not contact
another surface.
7. Mark the line of cut clearly.
8. Plug the reciprocating saw into an electrical outlet.
9. Hold the saw firmly with both hands. Make sure to keep your hands on the
insulated gripping areas only.
10. Depress the trigger switch to turn on the tool; allow it to come to the desired
cutting speed before applying the blade to the workpiece.
11. Do not force the tool. Place the shoe firmly on the workpiece while cutting.
Use only enough steady pressure on the blade to keep the saw cutting.
12. Reduce pressure as the blade comes to the end of the cut.
13. When sawing fibreglass, plaster, wallboard, or spackling compound, clean the
motor vents frequently with a vacuum or compressed air. These materials are
highly abrasive and may accelerate the wear on motor bearings and brushes.
OPER
A
TING INS
TRUCTIONS
WARNING!
• Always wear safety goggles when cleaning tools using
compressed air.
• Hold the tool only by the plastic handle and the insulated grip
area to help prevent electric shock. When sawing into walls or
floors you may encounter electrical wiring. Sawing into a “live”
wire will cause electric shock.
FPO