Maximum 054-0403-4, Инструкция по эксплуатации

Страница: 14 / 22

14
model no. 054-0403-4 | contact us 1-888-670-6682
OPER
A
TING INS
TRUCTIONS
BEFORE USING THE TOOL
Before starting the job it is advisable to test the
workpiece for the ideal temperature to use. The
description below gives an indication of the likely
heat settings required but always start with the low
heat setting.
The distance between the nozzle and the workpiece
will vary according to the material being worked on
but this should always be at least 2’’ (5 cm) or more
on any heat setting.
All applications, with the exception of removing paint
from the window frames, can be performed without
using a nozzle; however, for best results nozzles are
recommended.
PUTTING INTO OPERATION (See Fig. A)
1. SWITCHING ON/OFF
Switching on:
To put into operation, slide the on/off switch (5) to
position
I or II.
Switching off:
To switch off, slide the on/off switch (5) to position
0.
2. SETTING THE AIR FLOW AND TEMPERATURE (See
Fig. B)
The switch (5) can be set to two blower settings.
Suitable airflow and temperature combinations can be
selected according to the applications.
I =120 — 1100°F (50 — 600°C), 8.1 CFM (300 L/min)
II =120 — 1100°F (50 — 600°C), 13.5 CFM (500 L/min)
The air setting I is suitable for bending plastic and
heat-shrinking plastic.
The air setting II is suitable for stripping paint and
defrosting pipes.
Temperature can be adjusted in increments of 20°F
(10
° C) from 120°F (50 ° C) to 1100°F (600 ° C) by
pressing the temperature control button (12) on the
LCD cover (11).
°F or
°C
can be selected by pressing °F/
°C .
NOTE:
Before using the tool, read the instruction book carefully.
Fig. A
Fig. C
Fig. B
Fig. D
Fig. E