1-YEAR REPAIR WARRANTY
INSPECTION
A visual inspection must be made before each use of the stands, checking for cracks,
cracked welds and missing and/or damaged parts. If you notice anything wrong,
remove the stands from service until repaired or replaced. If you need assistance please
call our customer service department.
OWNER/OPERATOR RESPONSIBILITY
It is the owner's/operator's responsibility to read and understand all WARNINGS and
operating instructions on the product labels and instruction manual prior to operation
of these axle stands.
It is also the owner's/operator's responsibility to periodically inspect these axle
stands and labels, and maintain them in good working order.
ASSEMBLY
POSITIONING STANDS
REMOVING STANDS
• Raise the vehicle high enough to clear the stands.
• Remove the stands, being careful not to crawl under the vehicle.
• Slowly lower the vehicle to the ground.
This MAXIMUM product carries a one (1) year LIMITED warranty against defects in
workmanship and materials. This product is not guaranteed against wear or breakage
due to misuse and/or abuse.
The following are excluded from this 1-Year Repair Warranty:
a) Missing or damaged parts or components that are a result of abuse or misuse;
b) Any wear and tear to non-critical parts or accessories that do not affect the core
function of the product.
Made in China
Imported by MAXIMUM Canada, Toronto, Canada M4S 2B8.
• Remove all contents from box.
• Locate a base and remove the base connecting bolt.
• Slide end of outer shaft without saddle into base and align holes in base with holes in
outer saddle.
• Slide shaft out of outer shaft until base connecting bolt can be inserted through base
and outer shaft and secure with nut.
• Fully insert retaining pin through holes in outer shaft and shaft.
• Repeat above steps with other jack stand.
• Lift the vehicle following the jack instructions. Be sure to set the parking brake and
block the unlifted tires.
• Consult the vehicle owner's manual to determine the location of support points, then
position the stands beneath the ideal points. Do not crawl under the vehicle to
position the stands. Make sure both stands are at an equal height.
• To adjust stands: While holding shaft, remove retaining pin. Lift saddle to desired
height. Adjust height to locate nearest hole in shaft and align with the holes in outer
shaft. Insert retaining pin fully through holes in outer shaft and shaft.
• Slowly lower the vehicle onto the stands making sure the load is centred on the
saddles. Make sure the load and stands are stable.
OPERATION
OPERATION
WARRANTY
6
7
model no. 009-1627-6 | contact us 1-888-670-6682