3
SprayMate HVLP ST610 TNT
US
•
NEVER open the Spray Tanning System yourself to carry out electrical repairs!
•
DO NOT place the spray gun on its side, as material could leak out.
Grounding Instructions
This product must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current. This
product is equipped with a cord having a grounding wire with an appropriate grounding
plug. The plug must be plugged into an outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING - Improper installation of the grounding plug can result in a
risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the green grounding wire
to either flat blade terminal. The wire with insulation having a green outer surface with or without
yellow stripes is the grounding wire and must be connected to the grounding pin.
Check with a qualified electrician or serviceman if the grounding instructions are not
completely understood, or if you are in doubt as to whether the product is properly
grounded. Do not modify the plug provided. If the plug will not fit the outlet, have the
proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt ac circuit and has a grounding plug that looks
like the plug illustrated below. Make sure that the product is connected to an outlet having
the same configuration as the plug. No adapter shall be used with this product.
Grounded Outlet
Grounding Pin
Cover for grounded outlet box
Important Electrical Information
Use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot receptacle
that will accept the plug on the product. Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. A SJT type cord is required. Cord shall be 14 AWG minimum for
general indoor use.
SAVE THESE INSTRUCTIONS
