- 13 -
SWITCH ON THE HEAT FUNCTION
Press the key on the remote control to turn on the heat function. Press the key again to set the different
temperature levels in the sequence of LOW (A) > MEDIUM (B) > HIGH (AB), or press the key again to turn off the
heat function.
USE OF ELECTROSTIMULATION (IMPULSE FUNCTION)
Press the
key on the remote control to activate electrostimulation via the pulse emitters of the device. Press the
key again to select the different modes > PULSE (A) > ACUPUNCTION (B) > INTELLIGENT PULSE (AB). Press the
[+/-] key to control the intensity of the electrostimulation in 12 levels.
Note: The intensity of the electrical impulse should be set at a weak level at the beginning of the application and
then gradually increased.
Optionally, you can connect the two electrode pads supplied to the device and use them to additionally stimulate
your arms, legs, feet, back, etc. To do so, connect the two electrodes with the supplied cable and plug them into the
electric pulse output port provided on the device (see following fig.). Pull off the transparent protective foil on the
front of the electrodes and attach the electrodes to the desired body part (with the black side facing the body). To
control the impulse function proceed as described above. Apply the protective film again after use.
Note: Do not place the electrode pads near the neck. While using electrostimulation, you should not change your
body position.
9937620500_GA_Nacken_Massagegerät_230920.indd 13
9937620500_GA_Nacken_Massagegerät_230920.indd 13
29.09.20 11:17
29.09.20 11:17