www.maximatecc.com
Installation
Install the device in such a way that is considered safe and does not expose any unnecessary stress
to the unit. In this section, some recommendations are made regarding installation.
1.9
Connecting to power supply
This instruction address vehicle installations but the principle is the same also for other types of
installations. See also the description of the pin outs for the Power Supply Connector under the
section External interface description.
Carefully follow the connection instructions below. Make sure that all contacts are angled
correctly and that they do not have to be forced, but lock gently and pliant.
GND Pin J1-2 is connected to the vehicles ground.
Battery Pin J1-1, i.e. the display’s power supply (+12/+24 VDC), should be connected
directly to the vehicle’s battery through 10 A fuse (F1). Wire gauges shall be dimensioned
with respect to cable length, supply voltage etc. Minimum cable area is TBD.
The Switched Power Input Pin J1-3, i.e. the display’s on/off signal is connected via the
vehicles ignition switch (S1). The maximum allowed input current for the ignition switch
signal is 2 mA. The fuse F2 fuse rating and wire gauge shall be dimensioned for the total
switch current.
GND
1
2
F1
10 A
GND
BATTERY
S1
Connector (J1)
3
Min: AWG 16
Min: AWG 16
F2
XXm A
Unit A
GND
Unit B
GND
I
max
2 mA
Содержание CCpilot VI
Страница 1: ...1 1 Technical manual Date Jul 6 17 www maximatecc com Technical manual CCpilot VI ...
Страница 20: ......