Maxima ML-4030BC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 3 / 27

4
in contact with hot manifolds or moving fan blades.
5. If an extension cord is necessary, a cord with a current rating equal to or more
than that of the equipment should be used. Cords rated for less current than the
equipment may overheat. Care should be taken to arrange the cord so that it
will not be tripped over or pulled.
6. Always unplug equipment from electrical outlet when not in use. Never use
the cord to pull the plug from the outlet. Grasp plug and pull to disconnect.
7. Let equipment cool completely before putting away. Loop cord loosely around
equipment when storing.
8. To reduce the risk of fire, do not operate equipment in the vicinity of open
containers of flammable liquids (gasoline).
9. Adequate ventilation should be provided when working on operating
internal combustion engines.
10. Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
11. To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
12. Use only as described in this manual. Use only
manufacturer’s
recommended attachments.
13. ALWAYS WEAR SAFETY GLASSES . Everyday eyeglasses only have impact
resistant lenses; they are not safety glasses.
14. Inspect lift daily. Do not operate if it malfunctions or problems have been
encountered.
15. Never attempt to
overload the lift. The manufacturer’s rated capacity is shown
on the identification label on the power side column. Do not override the
operating controls or the warranty will be void.
16. Only trained and authorized personnel should operate the lift. Do not allow
customers or bystanders to operate the lift or be in the lift area.
17. Position the lift support pads to contact the vehicle manufacturers
recommended lifting points. Raise the lift until the pads contact the vehicle.
Check pads for secure contact with the vehicle.
18. Caution ! Never work under the lift unless the mechanical safety locks are
engaged.
19. Note that the removal or installation of some vehicle parts may cause a critical
load shift in the center of gravity and may cause the vehicle to become unstable.
Refer to the vehicle manuf
acturer’s service manual for recommended
procedures.
20. Always keep the lift area free of obstruction and debris. Grease and oil spills
should always be cleaned up immediately.
21. Never raise vehicle with passengers inside.
22. Before lowering check area for any obstructions.
23. Before removing the vehicle from the lift area, position the columns to prevent
damage to the lift and /or vehicle.
24. Check and adjust if need the correct air pressure in all tires before lifting. Do
not exceed tire load when raising vehicle.
25. DO NOT raise / lower only one side if a vehicle.
26. Lift only on same axle. Do not stagger between axles.
27. Do not drive over or pinch the electrical communication cables.
28. Do not remove hydraulic fittings while under pressure.
29. Check floor to ceiling height for clearance when vehicle is fully raised.