Maxima ML-4030BC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 11 / 27

10
Slave Control Panel
Control switches:

Power switch : (located on the right side of each column) w
hen this switch is at “OFF”, the
lift is powered off and no operation is available; when this switch is at “ON”, the lift is
powered on and prepared for operation.

Power light : when the power
switch is at “ON”, it illuminates.

Fault light : it illuminates when the carriages have overrun the limit synchronous value of
each column or the communication cables becomes loose, at this point all the other
switches do not work.

Mode selection knob : t
urn the knob to “SINGLE”, columns can be operated to go up and
down individually:
Turn the knob to “PAIR” or “ALL”, two columns/four columns/six
columns can be operated to go up and down together.

Emergency button : when you press this switch, no operation is available immediately.
There is one emergency button on each control box. It must be released before lift
operation then turn on the power switch.

“UP” button
: Press and hold this button, the carriages will rise.

“DOWN”
button: Press and hold this button, the carriages go down to the required height
after system unlocks the safety locks automatically.

“LOCK”
button: Press and hold this button, the carriage will slowly lower and lock onto
first lowest column.
Note:
Before turning Mode Selection knob, power off the lift and wait for 20 seconds.
“PAIR” mode can be used when four/six columns are communicating…A and B columns
become a pair, same with C and D columns. Use caution when using this function to keep
vehicle level.
“ALL” mode is used when there are four/six columns connected together.
“SINGLE” mode can be used to operate one column individually;
LCD
POWER light
Emergency button
Connector
Connector
“LOCK” button
“UP” button
FAULT light
“DOWN” button