Maxim 88801, Инструкция по эксплуатации, Страница: 6 / 12

5
Fig.8
Fig.10
Registration slot
Fig.9
Downrod
Canopy
Set screws
Hitch pin
Lock pin
Joint cover
Couping Ring
Screw
Screwdriver
Canopy
Screw
Canopy
Hanger Bracket
Tighten the screws
Mounting screws
(supplied with
electrical box)
Hook
Ceiling
mounting
plate
UL Listed
electrial
box
120V Wires
Washers
5. HANGING THE FAN
REMEMBER to turn off the power.Follow the
steps below to hang your fan properly.
Step 1. Loosen the screws on the canopy clock-
wise with a screwdriver and remove the hanger.
(Fig.8)
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 3. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket.
Step 4. Screws removed at canopy lock the bell
and hanger.
Step 5. Remove the hanger pin,lock pin and set
screws from the top of the motor assembly.
Step 6. Route wires exiting from the top of the
fan motor through the canopy and then through
the ball/down rod.(Fig.9)
Step 7. Align the holes at the bottom of the down
rod with the holes in the collar on top of the
motor housing.Carefully insert the hitch pin
through the holes in the collar and down rod.Be
careful not to jam the pin against the wiring
inside the down rod.Insert the locking pin
through the hole near the end of the hitch pin
until it snaps into its locked position.(Fig.9)
Step 8. Tighten two set screws on top of the fan
motor firmly.
Step 9. Place the down rod ball into the hanger
bracket socket.This will allow you to make the
electrical connections.(Fig.10)