70
Figure 5-28
Sample Repeat Screen
NOTE
In the case of a particle filter heavily loaded with soot, it can occur that the
regeneration request is blocked again after a short time or is not released. In
this case, it is required to regenerate the particle filter in a motorway or
cross-country trip taking approx. 30 minutes at a speed that is as constant as
possible. Subsequently, the service function “Particle filter regeneration”
must be run again.
During the regeneration phase and with the engine running, it can also occur
that the display for “Regeneration active” jumps to “Regeneration not active”.
This behavior can be seen exclusively with the vehicle stationary with the
engine.
Particle Filter Test
It is advisable to carry out a series of particle filter tests as a result of
constant DPF regeneration, such as checking oil level, oil change interval for
diesel contamination, swirl flaps, backpressure sensors and particle filter
soot remains.
1. Tap
Particle filter test
from the service functions menu.
2. The tool communicates with the vehicle and reads the fault codes
memory. If there is no relevant fault code stored in DDE, the screen
displays as below. Select
Cancel
to exit this function.
Содержание MX808TS
Страница 80: ...73 Figure 5 30 Sample IMMO Note Screen Figure 5 31 Sample Program Key FOB Screen ...
Страница 83: ...76 Figure 6 2 Sample Vehicle Manufacturer Selection Figure 6 3 Sample Vehicle Model Selection ...
Страница 128: ...121 Programmer Update Coming soon ...
Страница 162: ...155 Figure 17 3 Sample Function Viewer Screen 3 ...