Maxi Comet Executive Exec-56-G, Инструкция по эксплуатации

Страница: 66 / 244

Preventive Maintenance Comet Executive Gas
4-8
Grease “Weekly” Bearings
The grease fittings for the ironing cylinder
bearing (Figure 4-3, A) in the right endframe,
cam follower bearings (Figure 4-4, A) in the left
endframe, and compression roll bearings (Figure
4-3, B; Figure 4-4 B) in both endframes, are
marked with yellow “GREASE WEEKLY” tags
and need to be greased weekly.
Other bearings that are identified with the
yellow “GREASE” tags should also be greased
weekly if the unit is continuously run for long
periods.
A special high temperature lubricant is
required to properly grease all bearings. It is
important that only an EP, bentonite clay, NLGI
2, 1000 cSt viscosity grease be used.
Use of unsuitable grease can cause bearing
lockup or failure. Problems can also result if the
new grease is incompatible with the grease that
is already in the bearings.
Failure to use the correct lubricant will void
the factory warranty.
CAUTION
Before using a grease
other than specified, check
with the factory service
department to verify that
the grease meets
specifications and is
compatible with the grease
already in the bearings.
Figure 4-4: Add grease weekly to the fittings on
the cam follower bearings in the left
endframe.
A
B
A
Figure 4-3: Add grease weekly to the fitting for
the ironing cylinder bearing in the
right endframe and to the fittings for
the compression roll bearing in each
endframe.
A
B
TOC INDEX