53
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s latch plate.
7.
Attach Locking Clip
Thread both portions of
the vehicle belt onto the
locking clip, as close to the
latch plate as possible.
6.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the latch
plate and unbuckle.
NOTE:
If the latch plate
ends up just at the belt path
opening so you cannot grasp
the vehicle belt at the latch
plate, grasp the vehicle belts on the opposite side of the child
restraint, as close to the latch plate as possible.
54
Rebuckle Vehicle Belt
8.
NOTE:
The vehicle belt
MUST be threaded into
the belt positioning guide
as shown on both sides of
shell.
Check Vehicle Belt
Tightness
Grasp the child restraint
at the belt path
with one
hand. Push and pull the
child restraint from side to
side, forward and back. The
child restraint should not
move more than 1 in. (2.5
cm).
NOTE:
If it moves more than 1 in. (2.5 cm), redo steps 2
through 9 again or try another seating location.
Secure your child in the child restraint.
Recheck the recline angle to make sure it is reclined
according to your child’s weight.
Repeat steps if not reclined correctly.
Remove the locking clip when the vehicle seat
belt is not being used with a child restraint.
9.
5.
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the vehicle
shoulder belt to tighten.
4.
