Page
6
of
13
INSTALL THE AILERONS:
Push a T-pin or straight pin through the
center of each of the provided hinges.
The hinge slots are precut in the
leading edge of the ailerons and the
trailing edge of the wing. Push the CA
hinges into the slots in the ailerons so
that the pin is against the leading edge.
DO NOT GLUE THE HINGE IN YET.
Fit the ailerons by pushing the hinges
into the precut slots in the trailing edge
of the wing. NOTE: There are holes
drilled in the
bottom
of each aileron for
the control horns.
Bend the aileron down and then drip 2
drops of thin CA onto each hinge.
Remove the pins, then turn the wing
over and drip 2 more drops of thin CA
onto each hinge.
ASSEMBLE THE WINGS:
Remove the aileron servo hatches from
the bottom of the wing panels and
locate the small square hardwood
servo mounting blocks.
Position the blocks as needed for your
servo and glue them to the inside of the
hatch.
Use your transmitter to center the
servo. Use a long servo arm so that the
pushrod will not hit the wing surface
when it travels and
be sure to install
the screw that holds the arm to the
servo.
After the glue has set, install a servo on the back of each hatch using the hardware
that came with your servos.
Attach an 12 inch extension to the servo wire and secure the connection by tying,
taping, or shrink tube so that it won't come apart.
Feed the end of the extension through the wing and out through the center hole of
the root rib. Install the hatch in the wing using the M 2x10 self-tapping screws
