Maxell MXSP-TS1000, Инструкция по эксплуатации

Страница: 16 / 195

EN
EN-14
General Operation
Adjust the Volume
- Press the VOL+ / VOL- buttons on the unit or on the remote control to adjust the
volume.
- While adjusting the volume, the status indicator flashes quickly.
- While the volume level reaches its maximum level, if you press the VOL+ button again,
the status indicator flashes once. While the volume level reaches its minimum level, if
you press the VOL- button again, the status indicator flashes once.
Select a Preset Sound Effect
- While playing, press the FLAT, MOVIE and MUSIC button on the remote control to
select desired preset equalizers: MOVIE (recommended for viewing movies), MUSIC
(recommended for listening to music), FLAT (EQ mode off).
Tip: If there is no sound come out of the soundbar and the indicator light flash fast. Make
sure the digital audio setting of your source player (e.g. DVD player, game player, TV) is
setted to PCM output.
To keep the warranty valid, never try to repair the system yourself. If you encounter
problems when using this unit, check the following points before requesting for service.
Warranty void if case is opened.
Symptom Likely Cause What to do
No sound Speaker not connected to
active AC power
• Verify that speaker is connected and that the
circuit is on.
Power not switched on • Switch on power and verify that power LED is
on.
Suddenly No sound Triggered auto-off function • Turn the volume up of the source, e.g TV,
mp3 player, etc, and readjust the sound of
the unit to trigger auto-on function.
• See No Sound symptom above.
No sound, speaker is
connected to working
AC power but sound
won’t come on
Cannot trigger auto-on
function
• Increase the volume of the source input
signal.
Speaker power cable
is faulty or improperly
connected
• Re-seat the power cable at both ends.
• Substitute a know n-good power cable.
No sound. Speaker
comes on
Faulty cables and
connections
• Disconnect and re-seat signal cables.
• Make sure cables are plugged completely.
• Replace suspected cable with a known-good
cable.
Noise or hiss heard at
output
Faulty Cables and
connections
• Disconnect and re-seat signal cables.
• Make sure cables are plugged completely.
• Replace suspected cable with a known-good
cable.
Noisy source device • Disconnect the devices that are connected
to your speaker one at a time. If the noise
goes away, the problem is with the source or
the connecting cable.
Hum or Buzz that
increases or decreases
when more than one
source are inputting
single to the Soundbar
at the same time
Interference internally • Disconnect or mute the other channels to
solve the problem.
Faulty cable between
source equipment and unit
• Substitute a known-good cable for the
suspected faulty cable.
Remote control does
not work
No/Low battery power • Remove the transparent film at the bottom of
Remote control.
• Insert/Replace remote control battery with a
CR2025 battery. (see P.8)
The Soundbar does not
responds to the remote
control
No/Low signal from remote
control to the unit
• Reduce the distance between the Remote
control and the unit.
• Aim the Remote control directly at the sensor
on the front of the unit.
The unit responds but no
sound
• Before you press any function button, first
select the correct source.
• See Troubleshooting [No Sound] Symptom.
Improper connections
• Double check the Input/Output cable
connection .
Troubleshooting