8
1
2
3
Recommended body parts
Caution
Remove the protective sheet of the device
Place gel pads to the device. Attach the device onto the targeted area to begin training
Press the power button
Abdomen
Waist
Thigh
※
If gel pads do not attach to your body well, the “beep” sound
will continue and LED will flash, but the device will not work.
※
If the power is turned on without being attached to the body,
1 minute waiting time will start. please paste on your
body to use within 1 minutes.
When you hear a “beep” sound, LED flash and training begin.
When the device turns on, the intensity is preset as 1 (minimum).
※
Please paste the body according to
the direction of muscle texture.
• If you feel pain or numbness during use, switch off the device and try on a different position of your body.
• Do not forcibly increase the intensity.
• Traning steps will be switched automatically and does not support manual operation.
• When the device is stopped during the training, next training will start from the beginning.
• Use within 10-35°C.
• When removing the device, please proceed slowly and carefully. Electrode may be damaged when
peel with strong force.
• If the LED does not turn on or the electrical stimulus cannot be felt, the charge in the battery is low.
Please charge the battery.
• If there is no working or electrical stimulation, the gel pad may have deteriorated. Replace the original
gel pad.
• Be sure to disconnect the charging cable before use.
• The electrodes parts may darken depending on the method of use and frequency of use.
Usage
Before applying to the body, wipe off
sweat, moisture and dirt from the
skin. It may cause a decrease in
adhesive strength.
(Approx. 1sec)
Beep
Beep
Beep
Beep
Beep
Beep
4
Mode selection button
Three modes would be switched between by pressing the mode button.
※
Once mode is switched, intensity returns to 1.
Increase a strong feeling
of squeaking and tapping
in training
Intensive training in short time for
people who do not have time
Balanced training from
the shallow to the deep of
the body
a. Balance Mode
approx. 20mins
b. Hard Mode
approx. 15mins
approx. 10mins
c. Short Mode
Intensity selection
button
Power button
LED
Mode selection
button
6
5
Adjust intensity
• There are 25 levels of strength. Select “+” or “-” from the strength selection button. When you operate
the “+” or “-” button, it will have “beep” sound and the strength changes.
• When the strength level reaches 25 (maximum) or 1 (minimum), it will have “beep” sound.
Training finishes
• Remove the device in vertical direction
slowly
after use.
• After starting the operation, a mode approx. 20 mins, b mode approx. 15 mins,
c mode approx. 10 mins and then automatically closed.
• To turn off the power in halfway, press and hold the power button
(approx. 2 seconds) until you hear the beep sound, the LED light turns off
and the power is turned off.
