10
Maintenance of fitting belt
6
•
Do not use a washing machine or tumble dryer. Please hand wash.
•
Do not use chlorine bleach or softener.
•
Please avoid the direct sunlight.
•
Do not iron.
Weak sensation,
Device cannot
operate
intensity does not
increase
The time to press and hold the power
button is not long enough
Not using an original gel pad
Not using an original gel pad
Not using an original gel pad
Used continuously
The gel pad is not applied correctly
When the power button is pressed for
approximately 1 second, a beep sounds and
the power turns on.
Use original gel pads.
Use original gel pads.
Use original gel pads
For the same part,use once in a day
This device will stop after a mode approx.
20 mins, b mode 15 mins, c mode 10 mins.
Stick the blue film side to the main unit
Power supply automatically
turns off after several time
Problem
Cause
Solution
Cannot feel the
training/ Weak
sensation
Sensation is too
strong or feels
painful
Gel pads detached
from the device
Battery level is low
Charge the device
Gel pads not properly placed
Reattach the gel pads well and try again
Reattach the gel pads well and try again
Battery level is low
Charge the device
Troubleshooting
Power supply
cannot turn on
Continuous warning
sounds
There is air between the gel
pads and the device
Place the gel pads on the electrode and
squeeze the air inside using your finger tip
Extremely dry skin
Use water to moisten your skin and try again
Replace a new gel pads
Reattach the gel pads well and try again
Charge the device
Press "+" to increase intensity
Use water to moisten your skin and try again
Gel pads deterioration
Gel pads deterioration
Replace a new gel pads
Gel pads are not attached well
Not enough remaining battery
Intensity is too weak
Press "-" to increase intensity
Intensity is too strong
Extremely dry skin
Gel pads not properly placed
•
Due to the nature of the product, it may lose color. To avoid color transfer, do not wash with different
colors or leave wet after dehydration.
