Messages and Error Messages
0xFFFF Acknowledge
0xF000 Parameter is Read Only
0xF001 Invalid parameter ID
0xF002 Invalid Read/Write control value
0xF003
Data is below the minimum value for this parameter
0xF004
Data is above the maximum value for this parameter
0xF005
Parameter is being edited by the User from the Cygnus front panel
Reasons for Parameter is not changeable
0xD001 Security Code is set.
0xD002 System is Not Running
0xD003 System is Not Stopped
0xD004 System Type is not Rewind
0xD005 Security Code is set, or, System is Not Stopped, or, System is Not in Manual
0xD006 Security
is
LOCKED
0xD007 Security
is
UNLOCKED
0xD008 Security code did not verify, security is UNLOCKED
0xD009 Value is not in range
0xD00A Sensor Type is set to NONE
0xD00B Diameter sensor is set to NONE
0xD00C
Security Code is set, or, System in Not in Manual
0xD00D
Security is LOCKED, or, System is Not Running
0xD00E The same analog input can not be configured for multiple functions
0xD00F Undefined,
Load Cell calibration is complete
0xD010 Undefined, Auto Tune will be complete after a control is designed
0xD011 System is Not in Manual
0xD012 System is Not Running and In Auto Mode
0xD013 Tension On/Off is Not Toggle
0xD014 System is Not Stopped, or, Security is LOCKED
0xD015 Undefined,
Compensation is Optimal
0xD016 Undefined, The Oscillation may be an instability or an outside disturbance
0xD017 Undefined,
Stability is Optimal
0xD018 Undefined,
Calibrate Inertia/Accel complete
0xD019 Diameter Not received from Fieldbus
0xD01A System must be UNLOCKED, and, Running in Auto Mode, and, with Tension On
0xD01B Undefined, Not Stable? Switch to Quick Stabilize
0xD01C
Undefined, Gain Scheduling and Out-Of-Round compensation have been turned Off
0xD01D
System is Not in Hold, or, Tension is On.
0xD01E Gain Scheduling is active.
0xD01F Undefined, Remember to switch to Auto mode.
0xD020 Setpoint is configured for Remote analog input.
0xD021 Setup Number is configured for Remote analog input.
0xD022 Can not change while diameter type is Velocity/RPM
0xD023 Can not change Remote setup number while System is Not Stopped.