www.maxairrc.com
Page 17 of 19
Step 14 (continued…) – Mount the engine
The next step to complete the engine
installation is to mount the throttle servo.
The Velox Revolution II was designed to allow
for the throttle servo to be mounted on the right
or left hand side of the fuselage.
k. Place the throttle servo in the throttle
servo mount on the side of the fuselage
where the throttle assembly on your
engine is located.
l. Align the throttle so that the control rod
to the engine is able to move freely with
no binding.
m. Mark the holes and drill with a 1.5mm drill
bit. Drip some thin CA in the holes to
strengthen the hole.
n. When the CA has dried screw the throttle
servo to the mount and finish installing the
throttle control rod.
Install the throttle servo
Step 15 - Assemble and mount the fuel tank
a. The first step in assembling the fuel tank
is to slide plastic cover onto the supplied
screw. The slide the rubber stopper onto
the screw and sandwich the rubber
stopper with the metal base plate.
Screw the assembly together, but do not
tighten yet.
b. Slide the copper tubes into the stopper
assembly. You may use a 2 or 3 line
setup as per your needs.
c. Make sure that the vent tube is bent
upwards into the tank.
d. Slide the silicone fuel tubing onto the fuel
feed tube. Place the clunk on the other
end of the silicone fuel tubing and make
sure the length of the silicone tubing
allows it to move freely in the tank when
assembled.
Fuel tank components
e. Insert the stopper assembly in the tank and
tighten the screw to seal the tank.
f. Once the tank is assembled, place the fuel
tank on the fuel tank shelf in the front of the
fuselage as show below. Place some foam
rubber under the tank and secure to the
shelf. We like to use zip ties to secure the
tank.
Fuel tank secured to the fuselage
