www.maxairrc.com
Page 6 of 19
Main Wing Assembly
Step 1 – Install the ailerons
a. Remove the aileron from the wing.
b. Adjust the CA hinges so that they are
aligned properly in the hinge slots.
c. A pin can be inserted through the center
of the hinge to make sure it stays
centered.
d. Slide the aileron onto the hinges and butt the
aileron up against the wing.
e. Make sure there is no gap between the
aileron and the wing.
f. Drip some CA onto the CA hinges from the
top and the bottom of the wing.
g. Repeat for the opposite wing.
Be careful not to drip any CA onto the wing
covering.
Step 2 – Prepare the servo cutout
a. Locate the servo cutout on the bottom of
the wing. The dimensions can be seen
in the picture below.
Aileron servo cutout dimensions
b.
When cutting the covering to install
the servo, make sure to leave a 3mm
(1/8in) wide strip of covering that can be
ironed down in the servo cutout.
c. Cut the covering.
Leave a 3mm (1/8in) strip around the cutout
d. Iron down the overlapping covering and
around the servo cutout to make sure the
covering is secure.
e. The cutout allows for a standard size servo.
A high-torque servo is recommended.
Iron down the overlapping covering
f. Repeat for the opposite wing.
