21
<When no buzzer sounds but malfunction is suspected>
Symptom
Possible cause
Procedures to follow
Main switch is "ON" but
does not work
Dead battery
Switch to a new battery and confirm
whether it works
The tool does not
operate even if placed
against the rebar and
lowered.
The arm or curl guide is hitting an
obstruction.
Use rebar within the applicable
diameter.
Change the Attachment to the short
type.
Product does not
function
Auto Power-off feature operated
Try switching the Main switch (Fig.1.
e
)
from OFF to ON
Tying is not proper
Wire is touching rebars while tying
Tie so that wire is not touching rebars
Twisted off
Rebar size is not applicable
Use with supported rebars diameters
Tension adjustment dial is too tight
Adjust Torque dial (Fig.1.
c
)
Tension is too loose
Rebar size is not applicable
Use with supported rebar diameters
Tension adjustment dial is too
loose
Adjust Torque dial tighter (Fig.1.
c
)
Tie form is notably
deformed
Worn or broken parts
Immediately discontinue operation and
set the Main switch (Fig.22.
e
) at "OFF"
and remove the Battery pack
(Fig.22.
5
) before consulting. Then
contact the dealer where the tool was
purchased or MAX CO., LTD.
authorized distributors.
Increased frequency of
jamming
LED blinks
Tool is at an angle
The LED blinks when the tool is not
facing downward while in standby, but
this is not an error. Face the tool
downward when performing actual
tying.
Содержание ReBar Tier Twintier RB401T-E
Страница 2: ...Fig 1 Fig 2 Fig 3 Fig 4 21 22 29 31 30 23 36 2...
Страница 5: ...5 Fig 39 Fig 38 34 35 26 27 27 26 Fig 35 37 32 33 32 2 32 1 Fig 36 32 33 Fig 37 5...
Страница 62: ...62...
Страница 63: ...63...
