9
13. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12).
Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
15
15
12
12
Rod
Slot
Rod
13
8
58
58
14
12. Press two 1” Square Inner Caps (54) into the indi-
cated end of the Backrest Frame (15).
Attach a Plastic Foot (53) to the Backrest Frame
(15) with a #8 x 3/4” Screw (62).
Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four M6 x 45mm Screws (58).
12
53
62
15
54
14. Press two 2” Round Inner Caps (57) into the top
and bottom of the Leg Developer (19). Press two
1 3/4” Round Inner Caps (56) into the top and
bottom of the Leg Lever (7).
Lubricate a 3/8” x 2 3/4” Bolt (64) with grease.
Attach the Leg Lever (7) to the Leg Developer
(19) with the Bolt and a 3/8” Nylon Locknut (76).
Do not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
Slide two Foam Pads (26) onto the tubes on the
Leg Lever (7). Press two 1 1/4” Round Inner
Caps (78) into the tubes.
Repeat with the tube
on the Leg Developer (19).
14
Lubricate
7
19
57
78
26
Tube
Tube
76
64
78
56
56
57
