7
8.
Attach the Lat Tower (4) to the Upright (3) with
four 3/8” x 1” Button Screws (87) and four 3/8”
Split Washers (103).
Attach the Name Plate (89) to the Lat Tower (4)
with two #8 x 3/4” Screws (62).
4
3
89
62
62
87
87
103
106
7
8
5
76
17
66
3
30
6.
Pull the Seat Knob (45, not shown) out as far as
it will go, and slide the Seat Carriage (12) onto
the Bench Rail (5). Engage the Seat Knob into
the third hole from the end of the Bench Rail.
See the inset drawing. Thread the Hook (104)
into the bottom of the Bench Rail (5).
Do not
overtighten the Hook, or the Bench Rail will
be difficult to assemble in step 7.
Press the two Rail Inner Caps (99), with the wide
ends on the top or bottom (as indicated), into the
ends of the Bench Rail (5). Attach the Caps with
four #8 x 3/4” Screws (62).
Locate the Leg Lever Cable (32), which has three
ends connected in the middle with a bracket.
Route the end of the Cable with the eyebolt under
a “V”-pulley (92). Attach the “V”-pulley to the
Front Leg (6) with a 3/8” x 4 1/4” Bolt (81) and a
3/8” Nylon Locknut (76).
Slide the other two
ends of the Cable onto the Hook (104).
7.
Attach the Bench Rail (5) to the Upright (3) with a
3/8” x 5 1/2” Bolt (66), a 3/4” Spacer (17), a 7/8”
Spacer (106), and a 3/8” Nylon Locknut (76).
Fully tighten the Storage Knob (30) into the
Upright and the Bench Rail.
6
Third
Hole
99
Wide
End
Eyebolt
Wide
End
62
45
62
62
62
99
104
12
81
92
76
32
6
5
5
