To purchase, out of warranty, stainless steel replacement probes please mail us a check to the
address below and specify probe type:
PR-40H 6ft Hybrid probe - $20.00/ea”
Set of 2 probes $33.00/set
All prices include shipping & handling. NJ residents add 7% sales tax.
Attn Customer Service
Maverick Industries, Inc.
94 Mayfield Ave.
Edison NJ 08837
Replacement Probes
The transmitter frequency is 433.92 MHz
The max. transmission power is 1 mWatt
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Also while the Meat is flashing you can raise and lower the USDA doneness level (SET Temperature)
by pressing HI to raise it or LO to lower it. The FOOD temperature range is 32
o
F - 572
o
F.
Pressing SET button at any point will set the current settings. Not pressing any buttons for a few
seconds will also do the same.
Barbecue selection
Note: The unit will not allow you to set the maximum BARBECUE temperature below the
minimum BARBECUE temperature. It will automatically change the LO temp to 2 degrees below
the HI.
If you pressed SET in BARBECUE mode then the HI SET temperature will flash in the corresponding
probe field. Press HI to raise it or LO to lower it. The range for the HI SET temperature is 140
o
F 572
o
F. Default temperature from the factory is 250
o
F.
Press SET to set the HI SET temperature. The LO SET temperature will flash. Press Hl to raise it or LO
to lower it. The range for the LO SET temperature is
factory is 200
o
F.
Pressing SET button at any point will set the current settings. Not pressing any buttons for a few
seconds will also do the same.
–
Activating the temperature alarm
You can press the ALERT, ºC /ºF button to activate the temperature alarm for Both probe 1 and 2.
The alarm icons will appear above the actual temperature.
The receiver will beep with the alarm icon and probe temperature flashing if:
a) The actual FOOD temperature has exceeded your set maximum FOOD temperature.
(The alert Beeps 3 times every second if the temperature is within 6
o
C or 10 F of the set
temperature and beeps 4 times every second once the set temperature is reached)
b) The actual BARBECUE temperature has exceeded your set maximum BARBECUE temperature.
(Beeps twice in every second)
c) The actual BARBECUE temperature has fallen below your set minimum BARBECUE
temperature.
(Beeps once in every second)
Note if you press the ALERT, ºC /ºF button and the actual probe temperature is above the FOOD
set temperature or out of range of your BARBECUE set temperature then the Alert icon and the
actual probe temperature will flash immediately indicating the issue.
Note: The minimum BARBECUE temperature alarm will not be activated until the actual
BARBECUE temperature goes above the set minimum temperature.
For example:
You set the minimum BARBECUE temperature as 220 ºF and press the ALERT, ºC /
ºF, to activate the alarm. The unit will NOT beep or flash even if the actual BARBECUE
temperature is below 220 ºF. It assumes that your BARBECUE is not up to temperature. Only when
the actual BARBECUE temperature goes over 220 ºF, then falls below 220 ºF, can the alarm be
activated, the unit will beep and flash.
Note: The unit will retain your Barbecue & Food alert temperature settings even after the unit is
turned off.
Procedure for typical use in an outdoor barbecue
Monitor 1 FOOD and 1 BARBECUE
The following typical examples will go through the steps to have the ET-734 BIG GREEN EGG BARBECUE
alarm you if a piece of meat BEEF is cooked to 173 ºF and if your barbecue temperature falls
below 225 ºF or goes above 275 ºF.
Set up barbecue
1. Follow the registration procedure.
2. Place BEEF on the barbecue grill rack.
3. Insert probe 1 into the center of thickest portion of the meat. Avoid touching bone or heavy
fat areas.
4. Clip probe 2 to grill rack of barbecue grill rack.
5. Position the probe sensor wires so they will not come into contact with flames and exit the
barbecue without being pinched/ crushed by the cover.
6. Stand/ hang the transmitter away from heat source of barbecue. DO NOT put transmitter on
closed cover or under the cover. The transmitter is water proof for use in rain.
Probe 1: FOOD, BEEF, WELL DONE, SET TEMPERATURE 173 °F
1. Press and hold SET button for 2 seconds.
2. Press HI or LO button to switch flashing probe in upper left hand corner to (1).
3. Quickly press SET.
4. Press MODE button so FOOD is displayed.
5. Quickly press SET.
6. Press MEAT button until BEEF is displayed.
7. Quickly Press TASTE button until W.DONE is displayed.
8. Quickly Press HI button until 173 is displayed as HI SET.
9. Press set.
Probe 2: BARBECUE, 225 °F LO SET, 275 °F HI SET
1. Press and hold SET button for 2 seconds.
2. Press HI or LO button to switch flashing probe in upper left hand corner to (2).
3. Quickly press SET.
32
o
F 554
o
F. Default temperature from the
–
4. Press MODE button so BARBECUE is displayed.
5. Quickly press SET.
6. Press and hold HI or LO button until 275 is displayed as HI SET.
7. Quickly press SET.
8. Press and hold HI or LO button until 225 is displayed as LO SET.
9. Press set.
If the receiver and / or the transmitter display LLL or HHH instead of the probe temperature,
wait for probe to reach room temperature. If LLL or HHH is still displayed or you get a false
temperature, squeeze the probe jacks harder into the transmitter and twist them back and
forth so they make good contact. If the problem still persists it is likely the internal probe wire has
shorted out either through moisture or heat damage.
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into contact with flames.
Within the warranty period, return defective probe to address below along with return address
and we will send you a replacement probe at no charge.
If the temperature displayed seems to read too high or the temperature seems to increase too
quickly, check to make sure the probe tip is not poking through the food to outside. Reposition
the probe tip in the center of the thickest part of food. Avoid touching bone or heavy fat areas.
Helpful Hints
Cautions:
1) Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or
just after cooking. Do not touch with bare hands.
2) Keep the stainless steel probe sensors and wires away from children.
3) Clean the stainless steel probes and dry thoroughly after each and every use.
4) Do not use the receiver in the rain. It is NOT rain proof. The transmitter is rain proof but not
water tight. Do not immerse in water.
5) Do not expose the plugs of the stainless steel probes or the plug in holes of the transmitter to
water or any liquid. This will result in a bad connecting and faulty readings.
6) Do not expose the receiver or transmitter to direct heat or surface.
7) Do not use stainless steel probes in microwave oven.
8) The Barbecue Thermometer registers temperatures as low as 32 ºF (0 ºC) and as high as 572 ºF
(300 ºC). LLL will be displayed below 32 ºF and HHH will be displayed above 572 ºF. Do not use
the stainless probe sensor above 572 ºF. Doing so will deteriorate the wire.
9) Not Intended for Use by Persons ages 12 and Under.
Cleaning
1) Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or
just after cooking. Do not touch with bare hands.
2) Keep the stainless steel probe sensors and wires away from children.
3) Wash the metal probe tips with hot soapy water and dry thoroughly. Do not immerse the
probe in water while cleaning.
4) Wipe the transmitter and recei ver with damp cloth. Do not immerse either in water.
Information to user
LIMITED NINETY DAY WARRANTY
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the users’ authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generate, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
Maverick Customer Service
94 Mayfield Ave.
Edison NJ 08837
Telephone: (732) 417-9666
email: [email protected]
Do not send any parts or product to Maverick without obtaining a Return Authorization Number
and instructions.
This warranty is VOID if instructions for use are not followed; for accidental damage; for
commercial use; for damage incurred while in transit; or if the ET-734 BIG GREEN EGG BARBECUE
Thermometer has been tampered with.
This warranty gives you specific legal rights and you may also have other rights which vary from
state to state.
Maverick Industries Inc. warrants the ET-734 BIG GREEN EGG BARBECUE Thermometer to be free of
defects in parts, materials and workmanship for a period of 90 days, from date of purchase.
Should any repairs or servicing under this warranty be required, contact Maverick Customer
Service by email or mail for instructions on how to pack and ship the Thermometer to
Maverick’s National Service Center located as follows: ET-734 BIG GREEN EGG BARBECUE
