Maunfeld MBF 177BFW, Инструкции по установке, использованию и обслуживанию

Страница: 20 / 52

1025 20
Positioning and installing the appliance
EN
INSTALLATION IN THE TALL UNIT
HOUSING
The dimensions of the tall unit housing must correspond
to those reported in the igure.
3a
Insert the appliance in the housing against the side
panel adjacent to the opening. Check that the side
of the appliance is inset 53 mm in the unit.
3b
Adjust the foot until the top panel is not in contact
with the unit.
3c
Anchor the upper part of the appliance, using the
screws supplied, in the pre-drilled panel over the
front fascia.
3d
Anchor the centre of the appliance to the wall of the
unit using the special brackets.
3e
Fix the two bottom feet in the holes in the base of
the unit.
3f
Where provided, apply the plastic joint gasket.
3g
Check that the guides of door opener “
A
” are po-
sitioned opposite the opening, otherwise remove
them and replace on the other side.
3h
Fix guides “
B
”, supplied, on the fridge unit door
in the irst hole to allow the guide to rotate until it
engages fridge door opener “
A
”.
3i
Then screw in the other two ixing screws to ix
opener “
B
”, such that the guide is blocked and that
the door moves together with that of the unit.
CONNECTING THE APPLIANCE TO THE
MAINS SUPPLY
Check that the mains voltage corresponds to that indi-
cated on the appliance’s rating plate and that the mains
socket is equipped with an earth connection. Do not use
adapters that might generate overheating.
CLIMATIC CLASS
The appliance is arranged for operation in places where
the temperature comes within the following ranges,
according to the climatic class given on the rating plate.
Climatic Class Amb. T. (°C)
SN from +10 to +32
N from +16 to +32
ST from +16 to +38
T from +16 to +43
1773
1070
703
1780
560
560
540
5
48
3c
3
3d
3g
3e
3i
3h
A
3f
3b
B