MATSONIC MS9138E Series, Руководство пользователя

Страница: 33 / 47

3: BIOS Setup Utility
29
S.M.A.R.T. for
Hard Disks
Enable this item if any IDE hard disks
support the S.M.A.R.T. (Self-
Monitoring, Analysis and Reporting
Technology) feature.
BootUp Num-
Lock
This item determines if the Num Lock
key is active or inactive at system start-
up time.
Floppy Drive
Swap
If you have two diskette drives installed
and you enable this item, drive A
becomes drive B and drive B becomes
drive A.
Floppy Drive
Seek
If you enable this item, your system will
check all floppy disk drives at start up.
Disable this item unless you are using an
old 360KB drive.
Password Check
If you have entered a password for the
system, use this item to determine, if the
password is required to enter the Setup
Utility (
Setup ) or required both at start-
up and to enter the Setup Utility
(
Always ).
Boot to OS/2 >
64MB
Enable this item if you are booting the
OS/2 operating system and you have
more than 64MB of system memory
installed.
L2 Cache
Leave these items enabled since all the
processors that can be installed on this
board have internal L2 cache memory.
System BIOS
Cacheable
If you enable this item, a segment of the
system BIOS will be copied to main
memory for faster execution.
DOS Flat Mode
This item enables BIOS to enter the DOS
protected mode without other software
supporting under the DOS operating
system. We recommend you leave this
item at the default value.
SDRAM Timing
By SPD
This item allows you to enable or disable
the SDRAM timing defined by the Serial
Presence Detect electrical.