44
Chapter 3
Change Supervisor Password
This item allows you to set the system password which is
required every time when an attempt is made to enter the
Setup program. The password cannot be longer than six
characters.
If you want to disable the password which has already
been set, please follow the steps as follows:
1.
Press the <Del> key to enter BIOS Setup.
2.
Key in the current password then enter the BIOS setup
program.
3.
Choose the Change Supervisor Password item.
4.
Key in the current password to change the password.
5.
Then, press <Enter> key for new password. (It means
to disable the password, while the <Enter> key insteads
of the new password.)
6.
Press any key to exit the Change Supervisor Password
item, and then press <F10> key to save and exit BIOS
setup program.
Note: Keep a safe record of your password. If you forget or
lose the password, the only way to access the system is to
clear CMOS memory by holding down the <End> key
while powering or rebooting the system.
Auto-Detect Hard Disks
If your system has an IDE hard drive, you can use this
utility to detect its parameters and enter them into the
Standard CMOS Setup. This utility will autodetect up to
four IDE devices.
Save Settings and Exit
Select this item to save the entered values and then exit
the BIOS setup program.
Exit Without Saving
Select this item to exit the BIOS setup program without
saving the entered values.