Maintenance and Fault Finding
Maintenance
1.
Keep the jump start fully charged
2.
Recharge upon purchase and immediately after each use
3.
Recharge if not used for two months
4.
It is recommended to continuously the jump pack - the unit will not be damaged
Troubleshooting
Possible Solution
Problem
Charger works, but there is no volt charge on the
display when the Switching Power Charger is
connected to the jump pack
1.
Possible defective battery or faulty switch. Try
using a device - light, TV, etc with a DC plug
on it to see if it works
2.
If it works, the jump start battery is operational
and the switch may be faulty
Charger comes to full charge, but display indicates
low voltage
1.
Jump start has a defective battery - could be the
result of intense use without allowing a cool
down period
Jump start is fully charged, but has no power
1.
Check where the wire meets the jaw on the jump
start clamp. Ensure they are well crimped, or
2.
Ensure power switch is in the ON position.
Frequently Asked Questions - FAQ
Q:
How many jump starts can I expect from a fully charged unit before needing to be recharged?
A:
Depends on the engine type and size, condition of battery and temperature - the jump start may be
used up to 20 times before recharging in normal use environments.
Q:
What is the ideal jump start storage temperature?
A:
The jump start operates most effectively when stored at room temperature. The unit also operates at
below 0º conditions, but with less cranking power. Excessive heat accelerates self discharge.
Q:
When recharging the unit, when do I know the jump start is fully charged?
A: Check MAC02 Operating Instructions
Q:
How long should I charge the jump start?
A:
Charge the jump start for a minimum of 24 hours when first purchased. The unit can be left on the
wall charger continuously without damaging the unit.
Q:
Can the self contained battery be recycled?
A:
Yes - refer to REMOVAL AND DISPOSAL instructions
Q:
How often should I charge the RA3800?
RA3800 | 20150211
10
