Matrox 4Sight EV6, Установка и справочник по оборудованию

Страница: 25 / 116

Making your own open-wire power supply cable 25
3. Apply the tip of your soldering iron to each wire for a second; then, apply solder
to the wire. The solder should flow freely onto the wire and coat it. Clean off any
excess solder, if necessary.
4. Connect the exposed ends of your power supply cable into the power connector
latch. To do so, push the red wire into the positive (+) wire-terminal slot and the
black wire into the negative (-) wire-terminal slot.
1
Connect the chassis ground
wire-terminal ( ) to earth ground.
Warning
To ensure EMC conformity, you must connect the chassis ground wire-terminal
of your Matrox 4Sight EV6 unit to earth ground.
5. Secure the wires into their wire-terminal slots by tightening the screw associated
with the wire, at the bottom of the power connector latch.
6. Return to the Operating your Matrox 4Sight EV6 for the first time section for
instruction on how to connect the power connector latch to the power connector
of your unit.
1. Be aware that some power supplies might have different colors, verify the
polarity of your wires before attaching them.
o
Connection to
earth-ground
Power
supply
cable
+
-
- +
Power connector latch
Bottom
Screws to tighten
the wires in-place
Bottom