Matrix U5X-04 BIKE, Руководство по обслуживанию

Страница: 67 / 72

64
10.6 TV BRACkeT iNSTAllATioN iNSTRUCTioNS - CoNTiNUeD
CHAPTeR 10: Bike SPeCifiCATioNS AND ASSeMBly gUiDe
12) Press the entertainment keypad / overlay into the cut out in the console plastic (Figure M).
13) Plug the ribbon cable into the pins on the UCB (Figure N). Make sure that the pins and ribbon cable are correctly aligned with no pins open
on the UCB.
14) Mount the TV bracket to the console using 4 socket head screws sent with the TV bracket kit (Figure O).
15) Mye TV - Plug the 4 pin black connector side of the power wire into the UCB in the port marked TV Power for EP (Figure P). PCTV - Plug
the 4 pin black connector to the power wire coming up the console mast from the base of the unit.
16) Plug the side of the controller wire labeled To Console into the CSafe board mounted on the console back (Figure Q). The MYE TV should
be plugged into the TV port, the PCTV should be plugged into the PCTV port. If installing a PCTV, also change switch SW1 to the top location.
17) Route the net cable through the console. This wire is not plugged into the UCB, but should be routed through the console to hide the wire.
The 8 pin black connector on the net wire should stick out the bottom of the console along with the HR wiring (Figure R).
18) Connect one end of the coax cable to the board on the back cover using the adaptor sent with the TV kit (Figure S).
figURe M figURe N
figURe o figURe P
figURe q figURe R figURe S