10
11
Our equipment is heavy, use care and additional help if
necessary when moving. Failure to follow these instructions
could result in injury.
lEVElING THE UNIT
Locate a level, stable surface
to position the equipment.
The equipment has leveling
transport wheels located under
the ‘CONTROL ZONE’ cover.
To access grab the left and
right sides of the cover and
lift off. CAUTION There is an
electrical plug located under
the cover and will need to be
unplugged before the cover can
be completely removed. With
the CONTROL ZONE cover
removed adjust the transport
wheels until stable and lock
wheels into place. Once stable
plug the electrical connection
back together and place the
CONTROL ZONE cover back
into place.
MOUNTING THE
ClIMbMIll
Stand directly behind the
ClimbMill. grasp either the
upper or lower handle bars
and step onto the ClimbMill
until you are within comfortable
reach of the console and remote
handlebar controls.
lOCATION Of THE UNIT
Place the unit on a level surface. There should be 3 feet of clearance behind the unit and
one foot in front for the power cord. do not place the unit in any area that will block any
vent or air openings. These products should not be located in a garage, covered patio,
near water or outdoors.
Never operate product if it has a damaged cord or plug, if it is not working
properly, if it has been damaged, or immersed in water. Contact Customer Tech
Support for examination and repair.
pOWER
If your unit is powered by a power supply, the power must be plugged into the power
jack, which is located in the front of the machine near the stabilizer tube. Some units have
a power switch, located next to the power jack. Make sure it is in the ON position. Unplug
cord when not in use. NOTE: Some units have an ON/OFF switch located behind
the console.
HEIGHT REQUIREMENTS
The ClimbMill adds 30” – 38” (76cm – 96) to a user’s height. For example, a 6’ (183cm)
tall user will be 7’ 8” – 8’ 4” (234.4cm – 254.4cm) off of the floor. Total height of the
user on the ClimbMill should not exceed 9’ 10” (300cm), which means users taller than
6’ 8” (204cm) should not use this equipment.
WARNING
WARNING
USING THE HEART RATE fUNCTION
The heart rate function on this product is not a medical
device. While heart rate grips can provide a relative
estimation of your actual heart rate, they should not be
relied on when accurate readings are necessary. Some
people, including those in a cardiac rehab program, may
benefit from using an alternate heart rate monitoring
system like a chest or wrist strap. Various factors,
including movement of the user, may affect the accuracy
of your heart rate reading. The heart rate reading is
intended only as an exercise aid in determining heart
rate trends in general. Please consult your physician.
pUlSE GRIpS
Place the palm of your hands directly on the grip pulse
handlebars. Both hands must grip the bars for your heart rate
to register. It takes 5 consecutive heart beats (15-20 seconds)
for your heart rate to register. When gripping the pulse
handlebars, do not grip tightly. Holding the grips tightly may
elevate your blood pressure. Keep a loose, cupping hold. You
may experience an erratic readout if consistently holding the
grip pulse handlebars. Make sure to clean the pulse sensors to
ensure proper contact can be maintained.
3 ft
3 ft
92 cm
92 cm
1 ft
31 cm
3 ft
92 cm
climber_om_r1.7.indd 10-11
9/30/11 12:01 PM
