Installation
Page 12
5.3.3
Drive shaft angled sharply
Depending on the tractor, the drive shaft can be angled differently in the operating
position. If the drive shaft is angled too much, the service life is reduced. The angle of the
drive shaft can be reduced by extension (Order No. 131_7828).
Figure 11: Prolongation extension cat
5.4
Connect hydraulic connections of the sweeper to the tractor
Make sure the plug-in connectors are clean.
Hydraulic swivelling
The sweeper is equipped with a hydraulic swivelling unit. The two hydraulic hoses which
have to lead away from the swivel cylinder have to be connected to a free hydraulic cycle
on the tractor.
Hydraulic drive
If the sweeper is equipped with a hydraulic drive, the two hydraulic hoses (flow and
return) have to be connected to a free hydraulic cycle on the tractor. The litre capacity of
the cycle must suit the hydraulic engine.
If not enough hydraulic cycles are available on the tractor, an electro-magnetic switching
valve (Order No. 131_7746) is required.
