PROPER PART LOADING
Single Station Self-Centering Jaw Configuration:
• It is important to symmetrically load single or multiple parts axially on-center to the vise
to avoid excessive jaw twist
• Individual part clamped sides should be within .15mm (.006”) parallelism for clamping
on smooth jaw surface and within .51mm(.020”) when using the grips to provide
secure part retention
• When loading two or more parts on a 2-jaw vise, the clamped sides should vary in size
by no more than .15mm (.006”) when clamped on smooth jaw surfaces and no more
than .51mm (.020”) when using the grips to provide secure part retention
Double Station Center Jaw Configuration:
• Parts must be loaded on both sides of the center jaw. Symmetric loading still applies
• DynoGrip 52 with a center jaw allows for 2mm clamping size variation between parts*
DynoGrip 96 with a center jaw allows for 3mm clamping size variation between parts*
Jaw Range:
• Extending the jaws beyond the length of the vise body can reduce the effectiveness of
the jaw pull-down feature
CORRECT PART LOCATING
* See “Prep for Center Jaw Attachment” for correct setup on page 7 of instructions
