OPERATING PROCEDURE
MATADOR INSTRUCTION MANUAL
1. Open barbecue hood before attempting to light burners.
2. Set burner control knobs to "OFF" and open the gas
cylinder valve.
NOTE: Upon first assembly the gas lines and burners
will be full of air. In order for the burners to light
properly the lines must fill with gas. It may require
several attempts at lighting the burners before you
are successful.
3. Push and turn the required burner control knob to "HI".
4. Immediately press the Electric Ignition Button for up to
15 seconds to light the burner.
5. If the burner does not light, turn the burner control knob to
"OFF", wait 5 minutes for gas to clear, then retry.
your desired cooking temperature.
SIDE BURNER IGNITION
1. Open side burner hood before attempting to light side burner.
2. Set burner control knob to "OFF" and open the gas cylinder
valve.
3. Push and turn the control knob anti-clockwise
until a "click" is heard.
to light the burner. This may take 2-3 times.
4. Immediately the piezo igniter will be triggered
knob to "OFF", wait 5 minutes, then retry.
5. If the burner does not light, turn the control
IMPORTANT
If burner fail to light or go out during operation close gas supply
at source, and turn all burner controls OFF.
Open hood and wait 5 minutes before re-attempting to light
(Ensure accumulated gas fumes have cleared).
Should a grease fire occur, attempt to close gas supply
at source, turn off all burners and remove food if possible.
The hood must be in the open position for lighting.
Keep the ventilation openings of the cylinder enclosure free
and clear from debris.
Do not move trolley while barbecue is in operation.
The side burner is designed for use with a work up to 360mm
diameter, and cooking pan of up to 200mm diameter.
Use of very large pots may result in discolouration of the surface
finish, or cause poor combustion.
Do not smoke when attempting to ignite barbecue.
Never use volcanic rock. Heat beads or other material.
Always use protective gloves when handling hot components.
Ensure no packing material is left in BBQ before lighting appliance.
13
BURNER IGNITION
MAIN AND SIZZLE
6. Once the burner is ignited, adjust burner control knob
to desired flame level.
on page 17.
6. Once the burner is ignited, adjust burner control knobs to
7. If ignition cannot be achieved. Refer to "FAULT FINDING"
SYMBOLS: SIZZLE HIGH LOW
SIDE BURNER
