IMPORTANT
Before connecting and disconnecting barbecue to gas source,
make sure burner controls are in "OFF" position.
When the barbecue is not in use, the gas must be turned off at
the cylinder.
The appliance control knob must be in the "OFF" position
before opening the cylinder valve.
Check that the seals between the appliance and the gas
cylinder are in place and in good condition before connecting the
gas cylinder.
Do not use this appliance if it has damaged or worn seals.
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are
in ‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word ‘OFF’.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder
.
ENSURING BURNER CONTROLS ARE OFF
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
CONNECTING TO GAS SOURCE
assembly to cylinder
valve outlet.
Tighten firmly.
3.
Open the gas
cylinder valve fully
to allow gas to flow.
4.
Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting the barbecue.
Refer to Safety information, page 6.
5.
If a leak is found, turn gas cylinder valve off and re-check
all connections have been tightened. If there is still a leak
do not use barbecue until repairs or replacement can be made.
1.
Turn the burner controls
‘
OFF
’
.
2.
Turn the gas cylinder valve off fully.
3.
Detach the regulator assembly from gas cylinder
valve.
Familiarise yourself with the general information and
safety guidelines located at the front of this booklet.
Check to see that gas cylinder is filled and that end of
each burner tube is properly located over each valve
orifice. Set burner controls to
‘
OFF
’
position.
Direction for
tightening
Before first use and at the beginning of each barbecue
season:
1.
Please read
Safety, Lighting and Operating
instructions
carefully.
2.
Check gas valve orifices, burner tubes and burner
ports for any obstructions.
eg. spiders, webs, insects.
3.
Check and ensure the gas cylinder is full.
4.
Ensure all connections are securely tightened.
Check for gas leaks.
NOW YOUR BARBECUE IS READY TO USE
MATADOR INSTRUCTION MANUAL
DISCONNECTING FROM GAS SOURCE
Disconnect and remove gas cylinder when manoeuvring
the barbecue over uneven surfaces or carrying up and
down stairs.
12
When connecting to a fixed gas supply the installation
CONNECTION TO A FIX ED GAS SUPPLY
X
must be in compliance with
AS/NZS5601.
1.
Locate the gas cylinder in the cabinet and secure.
2.
Attach the regulator and hose
