28
CombiMaster 120V Series – User and Installation Manual
Menu
Description
Cluster L1 OUT
Output voltage
Total AC output voltage of the cluster on L1
Output current
Total AC output current of the cluster on L1
Output frequency Total AC output frequency of the cluster on L1
Output power
Total AC output power of the cluster on L1
Cluster L2 IN
Input voltage
Mains input voltage on L2
Input current
Mains input current on L2
Input frequency
Mains input frequency on L2
Cluster L2 OUT
Output voltage
Total AC output voltage of the cluster on L2
Output current
Total AC output current of the cluster on L2
Output frequency Total AC output frequency of the cluster on L2
Output power
Total AC output power of the cluster on L2
5.2.2 Alarms tab
The following table lists the parameters as shown in MasterAdjust.
Menu
Description
Temperature high
Internal temperature of the CombiMaster Inverter/Charger is too high.
Fan error
An error has been detected in (one of) the fan(s).
Battery
Temp.
Battery temperature too high / too low
DC high voltage
Battery voltage is too high.
DC low voltage
Battery voltage is too low.
Overload
The loads exceed the nominal inverter power
Device error
Internal CombiMaster Inverter/Charger error.
AC IN error
AC input voltage or frequency out of range
5.2.3 History tab
The following parameters are only shown in MasterAdjust.
Menu
Description
Inverter runtime
Inverter mode operation hours
Charger runtime
Charger mode operation hours
Parameters marked with a
are not available in CZone.
5.2.4 Configuration tab
The configuration can be done in MasterAdjust, from a laptop or notebook connected to the
CombiMaster Inverter/Charger via a Mastervolt USB Interface. See applicable user manuals for details.
The following table lists the parameters as shown in MasterAdjust.
Notes: -
DIP switch settings overrule MasterBus settings. If DIP switches are not in their default setting,
the corresponding MasterBus setting is greyed out.
-
To be able to make changes to the configuration via MasterBus, DIP switch 1 must be in the
ON position.
-
Bulk, absorption and float settings are read only, unless battery type "user defined" is selected.
