11
OPERATION
WARNING:
The maximum blade capacity of your saw is 7-1/4 inches. Any
blade larger than 7-1/4 inch will come in contact with the blade guards. Never
use a blade that is so thick that it prevents the outer blade washer from engag-
ing with the flat side of the spindle. Blades that are too large or too thick can
result in an accident causing serious injury.
SAW BLADES
All saw blades need to be kept clean, sharp, and properly set in order to cut
efficiently. Using a dull blade places a heavy load on the saw and increases
the danger of kickback. Keep extra blades on hand, so sharp blades are
always available. Gum and wood pitch that have hardened on the blade will
slow the saw. Use gum and pitch remover, hot water, or kerosene to remove
these substances.
Do not
use gasoline.
BLADE GUARD SYSTEM (Fig. 3)
The lower blade guard is
there for your protection and
safety. It should never be
altered for any reason. If the
lower blade guard becomes
damaged or begins to
return slowly or sluggishly,
do not operate your saw
until the damaged part has
been repaired or replaced.
Always leave the guard in its
correct operating position
when using the saw.
DANGER:
When sawing through a workpiece, the lower blade guard does
not cover the blade on the underside of the workpiece. Keep hands and fin-
gers away from the cutting area. If any part of your body comes in contact with
the moving blade, serious injury will result.
CAUTION:
Never use the saw when the lower blade guard is not operating
properly. The lower blade guard should be checked for correct operation be-
fore each use. If you drop your saw, check the lower blade guard and bumper
for damage at all depth settings before using.
NOTE:
The lower blade guard is operating properly when it moves freely
and then readily returns to the closed position. If, for any reason, your lower
blade guard and bumper do not close freely, take the saw to your nearest
Repair Center for service before using it.
Fig. 3
1/4 in. or less of the Blade is exposed on
the underside of the workpiece
Lower Blade Guard level
is in UP position when
making a cut
Lower Blade Guard
retracts automatically
when cut is being made
