MasterForce 241-0400, Руководство оператора

Страница: 8 / 26

8
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a live wire will make exposed metal parts of the tool
live and shock the operator.
Use protective gloves when removing the bit from the tool, or first allow
the clamp to cool down. The bit may be hot after prolonged use.
Use protective gloves when operating the tool. Protective gloves can help
to keep you from being burnt and hurt.
Keep your hands away from the motor-housing vents. Hot gas comes from
the vents during operation.
Do not operate the tool at full-load for more than 30 seconds, as this can
cause the motor to become too hot, which may damage the motor.
Release the trigger immediately when the screws are tightened to avoid
breaking the screw.
For best results, your battery tool should be charged in a location where
the temperature is more that 41
0
F (5
0
C) but less that 104
0
F (40
0
C). Do not
store outside or in vehicles.
SAFETY RULES FOR CHARGER
WARNING! Read and understand all instructions. Failure to follow all in-
structions listed below may result in electric shock, fire, and/or serious per-
sonal injury.
Before using the battery charger, read all instructions and cautionary
markings in this manual and on the battery charger, the battery, and the
product using the battery to prevent misuse of the products and possible
injury or damage.
CAUTION:
To reduce the risk of electric shock or damage to the charger
and battery, charge only these rechargeable batteries specifically designated
on your charger’s label. Other types of batteries may burst, causing personal
injury or damage.
Do not use the charger outdoors or expose it to wet or damp conditions.
Water entering the charger will increase the risk of electric shock.
Use of an attachment not recommended or sold by the battery-charger
manufacturer may result in a risk of fire, electric shock or injury to
persons.
Do not abuse the cord or charger. Never use the cord to carry the charger.
Do not pull the charger cord to disconnect the plug from receptacle.
Damage to the cord or charger could occur and create an electric shock
hazard. Replace damaged cords immediately.