This section describes the procedures for obtaining desired
performance. Flow rate is determined by the drive speed and
the tubing size.
WARNING: Tubing breakage may result in fluid
being sprayed from pump. Use
appropriate measures to protect
operator and equipment.
Turning Pump System On and
Selecting Direction of Operation
The Pump System can be set to operate in either a clockwise
or a counterclockwise direction. The same control used to
select direction also turns power on or off. Select direction of
pump operation desired. PWR indicator should light.
Setting Pump Speed
Pump speed is controlled by the variable Speed Control.
Turning the control clockwise increases the speed. Tube life is
decreased with increased operating speed.
Priming Pump System
The MAX Push Button is used for priming and purging the
Pump System. When MAX is depressed, the pump operates
at maximum speed in the selected direction until the button
is released. Approximately two feet of tubing length can be
filled or emptied per minute using the MAX Push Button on
the 10 rpm units.
7
®
OPERATION
DANGER: Remove power from the Pump System
before any cleaning operation is started.
Cleaning
Clean exterior surfaces of case, control panel and pump
rollers using dry or damp cloth. Never immerse nor use
excessive fluid.
Replacement Parts and Accessories
Item Part
No.
Rubber Feet (4 ea.)
A-1390-0001-CR
Shorting Bar
A-4402
Pump Assembly 3 Roller
111185-CR
Pump Assembly 4 Roller
111186-CR
Accessory Part
No.
Mounting Brackets (2/set)
77120-03
Universal Power Supply 100-240V AC
77200-07
MAINTENANCE
