Never turn the chop saw On with the cut-off disc touching the work
surface.
Use only cut-off discs in compliance with ANSI Standard B7.1 and rated for
a speed greater than 3800 RPM.
Do not use the chop saw if the disc flanges or cap screw are missing or
improperly installed.
Dust and abrasive materials should not be allowed to build up in the
workshop. Hot metal sparks could start a fire.
Do not remove the soft paper in the centre of the cut-off disc.
Do not alter or enlarge the centre hole of the cut-off disc, as this could
result in the disc shattering.
EXTENSION CORD SAFETY
WARNING:
Keep the extension cord clear of the working area.
Position the cord so it will not get caught on the workpiece, tools or any
other obstructions while you are working with the power tool.
Make sure any extension cord used with this tool is in good condition.
When using an extension cord, be sure to use one of heavy enough gauge
to carry the current the tool will draw. An undersized cord will cause a
drop in line voltage, resulting in loss of power and overheating.
The table below shows the correct size to use according to cord length
and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
Be sure your extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it repaired by a
qualified electrician before using it. Protect your extension cord from
sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your power tools. This circuit must not
be less than 14 gauge wire and should be protected with either a
15 A time-delayed fuse or circuit breaker. Before connecting the power
tool to the power source, make sure the switch is in the Off position and
the power source is the same as indicated on the nameplate. Running at
lower voltage will damage the motor.
!
MINIMUM GAUGE (AWG) EXTENSION CORDS (120 V USE ONLY)
Amperage rating
Total length
More
than
Not more
than
25’
(7.5 m)
50’
(15 m)
100’
(30 m)
150’
(45 m)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not applicable
12
13
model no. 055-6701-6 contact us 1-800-689-9928
I
SAFETY GUIDELINES
SAFETY GUIDELINES
Содержание Maximumu 055-6701-6
Страница 1: ......
