MasterCraft MAXIMUM 054-1232-4, Инструкция M

Страница: 15 / 19

29 28
model no. 054-1232-4 | contact us 1.800.689.9928
CUTTINg CIRCLeS (fig 20)
This requires using a circle cutting/
straight edge guide (sold separately).
1. Before attaching the edge guide, draw
a circle and drill a hole in the centre of
the circle.
2. Drill or plunge cut near the edge of the
circle.
3. Turn the saw off, and disconnect the
plug from power source.
4. Attach the edge guide to the saw (the same way you attached the included
edge guide), with the edge guide facing up.
5. Place the metal centre point on the edge into the hole in the centre of the
circle. In order for the edge guide to cut a circle, the metal centre point must
be aligned with the saw blade.
6. Measure the distance from the selected hole to the blade. This distance is
equal to the radius of the circle.
7. Insert the saw’s plug into a power source.
8. Hold the saw firmly, squeeze the trigger switch, and slowly push the saw
forward.
MAINTeNANCe
befORe eACh USe:
• Inspect the orbital jigsaw, the on/off switch, and the cord for damage.
• Check for damaged, missing, or worn parts.
• Check for loose screws, misalignment or binding of moving parts, or any other
condition that may affect the operation.
• If abnormal vibration or noise occurs, turn the saw off immediately, and have
the problem corrected before further use. Unplug the saw from the socket
before cleaning or performing any maintenance. Using compressed air may
be the most effective cleaning method. Always wear safety goggles when
cleaning tools using compressed air.
• If the power cord is damaged, it must be replaced with an identical
replacement part and be installed by an authorized service technician.
fig 20
NOTe:
To make a hole, cut from inside the circle. To make wheels or discs,
cut from outside the circle.
wARNINg!
• Do not let brake fluids, gasoline, petroleum-based products,
penetrating oil, etc. come into contact with plastic parts. These
substances contain chemicals that can damage, weaken, or
destroy plastic.
• When servicing, use only identical replacement parts. The use
of any other parts may create a hazard or cause damage to the
product.
• Use only accessories that are recommended for this saw by the
manufacturer. Accessories that may be suitable for one tool may
become hazardous when used with another tool.
• Maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools with sharp cutting edges are less
likely to bind, and are easier to control.
• To ensure safety and reliability, all repairs should be performed
by a qualified service technician.
FPO
MAINT
e
NANC
e
O
P
e
R
A
TIN
g
INS
TRUCTIONS