MasterCraft MAXIMUM 054-1232-4, Инструкция M

Страница: 11 / 19

21 20
model no. 054-1232-4 | contact us 1.800.689.9928
AdJUSTINg The bASe PLATe fOR
beVeL CUTTINg (figs 11, 12)
1. Unplug the saw and remove the blade.
2. To adjust the cutting angle, first turn
the tool upside down and pull the dust
extraction port to remove it from the
tool.
3. Use the hex key to loosen the hex
screw securing the saw base.
4. Move the base of the saw slightly
forward, and tilt it to the required
angle, between 0° and 45°, using the
scale marked on the base bracket.
5. Install a cutting blade.
6. Slide the blade guide assembly until
the blade guide rests against the back
edge of the blade.
7. Re-tighten the hex screws. For accurate
work, it is necessary to make a trial cut,
measure the work, and reset the angle until the correct setting is achieved.
USINg The edge gUIde (fig 13)
The edge guide (included) is used for
straight cutting:
1. Insert the bar of the edge guide
through the slots in the base of the
orbital jigsaw. It can be inserted from
either side of the base, with the edge
guide facing down.
2. Screw the edge-guide locking knob
into the threaded hole in the base in
order to tighten the edge-guide bar in
place.
3. Measure the distance from the edge
of the workpiece to the cutting line.
Slide the edge guide to this desired
distance, and tighten the locking knob
in order to secure the edge guide in
place (fig 14).
CAUTION!
• Always remove the blade before adjusting the cutting angle.
• In order to prevent damage to the tool when angle or bevel
cutting, the scroll mechanism must be locked in place, with the
cutting edge of the blade facing the front of the tool.
wARNINg!
• Do not let familiarity with your saw make you careless. Remember
that a fraction of a second of carelessness is sufficient to cause
severe injury.
FPO
fig 11
fig 13
fig 14
wARNINg!
• Always unplug the saw from the power source before making
any adjustment or attaching accessories.
FPO
A
S
S
e
M
b
LY INS
TRUCTIONS
A
S
S
e
M
b
LY INS
TRUCTIONS
fig 12