headline bars
continuation tabs
notes
warnings
5
headline bars
continuation tabs
notes
warnings
QUICK ST
AR
T GUIDE
Place the battery (sold separately)
into
the control box. Connect the leads
from controller: Red+ to battery Red+;
Black- to battery Black-.
Note: Be sure the battery box
ventilation holes are unobstructed.
Battery control box must be set up in a
well-ventilated area. Smoking and open
flames are prohibited.
4
6
Hook the backup pump switch clamp
over the switch mounting bracket.
Adjust the switch assembly location
along the discharge pipe so that the
backup pump float lower point is above
the primary pump “ON” position.
Tighten the mounting clamp of the
backup pump switch.
5
To connect the balance pipes, plug the backup
pump and the float switch wire male terminal
into the female terminal on the control box.
Plug the 12 V transformer outlet plug into the
power connector marked “POWER” on the
control box. Plug the transformer into a 115 V
GFCI power outlet.
Please refer pg 14 to do necessary testing. After
testing, plug the primary pump plug into the
piggyback switch plug outlet, and then plug the
switch plug into a 115 V GFCI outlet.