MasterCraft 054-8296-0, Инструкция по эксплуатации

Страница: 14 / 20

headline bars
continuation tabs
notes
warnings
model no. 054-8296-0 | contact us 1-800-689-9928
14
OPERA
TING INSTRUCTIONS
5. Shave hook
Take the handle from the set, remove the nut from the end,
and fit the triangle blade in place by refitting and tightening
the nut. The triangular shave hook is ideal for stripping paint
from flat wooden surface and edges.
Remember to clean the blade after use with wire wool and
lightly oil before storing.
REMOVING PAINT
Choose the required nozzle and fit onto the heat outlet. Select the scraper or shave hook required. Hold the gun with
the nozzle approximately 2’’ (5 cm) from the surface of the paintwork and start with the lower heat setting move it
slowly backwards and forwards until the paint blisters and bubbles. Immediately remove the paint with the scraper or
shave hook. Aim to heat the paint just ahead of the scraper so that you can develop a continuous action. Do not heat
the paint for too long, as this will burn the paint making it difficult to remove.
Most stickers can also be removed from paintwork by using the heat to soften the adhesive. Be careful not to direct the
heat for too long if you are trying just to remove the stickers, as this will blister the paint.
REMOVING PAINT FROM WINDOW FRAMES
WARNING:
Glass can break easily.
Always use the glass protection nozzle. Ensure you have the nozzle facing the correct way to deflect the heat away
from the glass before you switch on. Rotate the gun or nozzle 90º as you move to horizontal or vertical bead. Allow
nozzle to cool before attempting to turn it. Paint can be removed from profile surfaces by using a shave hook and/or a
soft wire brush.
DEFROSTING FROZEN PIPES
WARNING:
Do not attempt to defrost PVC pipes. Always check that it is a water pipe and not a gas pipe. Do not heat a
gas pipe.
Choose the hook nozzle (10) and fit over the nozzle (1). Always heat from one or other end of the frozen portion, not
from the middle.
SHRINK-SEALING ELECTRICAL CABLE
Choose the hook nozzle (10) and fit over the nozzle (1). Select a heat-shrinkable sleeve with a diameter matching that
of the workpiece. Evenly heat the sleeve.
Fig. A
Fig. B1
8
9
11
10
3
Fig. B2
Fig. B3
Fig. B4
Fig. B5
Fig. C
Assemble shave hook