MasterCraft 054-8251-6, Инструкция по эксплуатации

Страница: 7 / 13

CORDED MULTI-CRAFTER KIT - 054-8251-6 CORDED MULTI-CRAFTER KIT - 054-8251-6
11 12
NOTICE:
Attach the application tool in the desired orientation for the task at hand. The ribs on the shaft
and the grooves in the application tools permit a firm connection of the application tools in increments
of 45° around the shaft, from 0°to 90° left and right (fig 5).
90° 45° 0° 45° 90°
fig 5
WARNING!
The flush cut blade, the scraper blade
and the segmented saw blade should
never be attached so that they are
facing backwards, as operation in this
position may cause serious injury (fig 6.)
Attaching the application tools
(fig 3-5)
WARNING!
Failure to unplug the tool from the power
source when assembling parts, making
adjustments, or changing application
tools could result in accidental starting
and cause serious injury.
WARNING!
For all work or when changing
application tools, always wear
protective gloves. The sharp edges
of the application tools will cause
personal injury. Application tools can
become very hot during use.
WARNING!
Check that the application tools are correctly attached. Use only the original Mastercraft
accessories and the other approved accessories (Fein
®
and Rockwell Sonicrafter
®
accessories) without adaptor. Incorrect or insecurely fastened application tools can come
loose during operation and cause a hazard.
1. Disconnect the multi-crafter from the power.
2. Loosen the flange bolt with the hex key provided (fig 3).
3. Ensure that the inner threads and the drive shaft are clean.
4. Align the grooves on the application tool with the four raised ribs on the drive shaft; put the
application tool onto the drive shaft (fig 4).
5. With your gloved hand holding the blade, put the flange bolt on the tool and tighten it with the hex key.
OPERA
TING INSTR
UCTIONS
OPERA
TING INSTR
UCTIONS
fig 3
fig 4
Ribs on
shaft
Grooves
fig 6